Skip to content
MeasureToBuy

Concrete Steps Calculator

Enter the total rise from the ground to the door or porch, the tread depth and the width. You'll get the step layout, code checks, and the concrete to order in bags or ready-mix.

Structural sizes — footings, framing, stairs — are governed by local building codes and site conditions. Use this for material planning, and confirm sizes with your building department or an engineer.

Measurements

From the ground (or walkway) at the bottom to the top landing or door threshold.

The IRC maximum is 7¾ in (196 mm).

The IRC minimum is 10 in (254 mm); 11–12 in feels better outdoors.

At least 36 in (914 mm) under the IRC.

At least 36 in in the direction of travel at a door. 0 if the steps meet an existing porch or slab.

Waste allowance

Covers uneven ground, form bowing and spillage. 5–10% is standard.

Bag size

0.60 cu ft per bag

Your estimate

You need about 1.12 cubic yards of concrete for 3 steps and a landing.

3 risers of 7 in, solid poured, plus 10% waste.

Concrete volume
1.02 cu yd
Same volume
27.4 cu ft
Waste allowance
10%
Volume with waste
1.12 cu yd
80 lb premix bags0.6 cu ft per bag
51 bags
Or ready-mix orderrounded up to ¼ yard
1.25 cu yd
Approximate weight
4,519 lb

Step layout

Risers
3 risers
Riser height
7 in
Treadsthe landing is the top step
2 treads
Total run (excluding landing)
22 in
Top landing
36 in
  • This is the volume of solid steps. Hollow-formed steps or steps poured against an existing foundation wall use less.
  • Steps need a stable base below the frost line in cold climates — check your local footing requirements.
Steps · profile
21 inrun 1.83 ft7 in11 in3 RISERS · 2 TREADS
Every riser is the same height. With a landing, the landing is the top step, so there is one fewer tread than risers.

Next step

Pouring a walkway to the steps?

Add up slabs, footings and other shapes in the concrete calculator.

Concrete calculator

Also useful

Reinforcing the landing?

Lay out a rebar grid for the landing slab.

Rebar calculator

How to measure

  1. Measure the total rise: from the ground or walkway at the bottom of the steps straight up to the top landing level.
  2. Decide the tread depth (front to back) and the width of the steps.
  3. At a door, plan a top landing at least 36 in deep. Set it to 0 if the steps meet an existing porch or slab.

How the concrete steps calculation works

Risers  = ceil(total rise ÷ max riser);  riser = total rise ÷ risers
Treads  = risers − 1 with a landing (the landing is the top step), else risers
Steps   = width × tread × riser × t(t + 1) ÷ 2
Landing = width × landing depth × total rise
Order   = (steps + landing) × (1 + waste)

Solid poured steps are a stack of blocks: the bottom step is one riser tall, the next two, and so on. Adding them gives the triangular-number formula t(t + 1) ÷ 2. The landing sits at the full height.

The layout uses the IRC limits: risers no taller than 7¾ in, treads at least 10 in, stairs at least 36 in wide, and landings at least 36 in deep in the direction of travel.

Worked example

A 21 in rise to a back door, 11 in treads, 48 in wide, with a 36 in landing and 80 lb bags.

  1. Risers: 21 ÷ 7.5 = 2.8 → 3 risers of 7 in; 2 treads plus the landing
  2. Steps: 48 × 11 × 7 × 2 × 3 ÷ 2 = 11,088 cu in
  3. Landing: 48 × 36 × 21 = 36,288 cu in; total 47,376 cu in = 27.4 cu ft (1.02 cu yd)
  4. With 10%: 30.2 cu ft ÷ 0.6 cu ft per bag = 50.3 → 51 bags

You need about 1.12 cu yd with waste — 51 bags of 80 lb premix, or a 1¼ yd ready-mix order.

How much extra to allow

Forms bulge and the ground under the bottom step is rarely flat, so order 5–10% extra.

SituationAllow
Tight, braced forms5%
Typical DIY forms10%

Reading your result

Every riser comes out identical — the calculator divides the total rise evenly, which is what the code's ⅜ in variation limit requires.

Above about 1½ cubic yards, ready-mix is usually cheaper and much faster than mixing bags.

Assumptions

  • Steps are solid concrete; formed hollow steps or steps poured against a wall use less.
  • Riser, tread, width and landing limits are from the 2021 IRC (R311.7); your town may amend them.
  • An 80 lb bag of premix yields 0.60 cu ft.

Unit conversions use exact definitions (1 in = 25.4 mm, 1 US gal = 3.785 L). See the calculation methodology for rounding rules.

When to call a professional

  • In cold climates, steps attached to a house need footings below the frost line or they heave. Check your local footing and handrail requirements before pouring.

Frequently asked questions

How much concrete do I need for 3 steps?

For three 7 in risers, 11 in treads, 4 ft wide with a 3 ft landing: about 27 cu ft (1 cu yd) before waste — roughly 51 bags of 80 lb premix with 10% extra.

What is the maximum step height for outdoor stairs?

The IRC limits risers to 7¾ in (196 mm) with treads at least 10 in (254 mm), and riser heights may vary by no more than ⅜ in within a flight. Local codes can differ.

How big does the landing at a door need to be?

At least as wide as the door it serves and 36 in deep in the direction of travel under the IRC.

More concrete & masonry calculators

All concrete & masonry